Before you castigate yourself, take it easy that you could replace your Nintendo DS case isolated. In any case, be forewarned, it is a problematic movement. You need novel instruments and LOTS of ingenuity. If you do not think you have the stuff, it is for each situation better to send it in the nearest trusty store for fix. Would it be a good idea for you to have the guts to do this current, we should start. Exactly when you are peaceful and arranged to camouflage your Nintendo DS case, place a texture or towel for base and keep a saucer accommodating to put in the screws. By then, oust the battery case screw on the down right corner, two distinct screws on the left side, and the screw on the DS card space. Take the battery off. remove the screw and the spread inside too.
After all screws are ensured about on your saucer, remove this back warily. Oust all parts from the shell, anyway be careful on the off chance that you are clearing the shoulder attaches as they have springs that may jump out. Take out the profoundly differentiating joins near the DS card opening, and take the dim one underneath the space to the contrary side. By then oust the screws on either side. You would now have the option to oust the PCB from the other segment of the base bit of your vital switch frill case. Oust the two screws on top A-B-X-Y attaches, and flip the dull bar over the heading pad upside to snap off the level wire and delicately take it off downwards. By and by turn your DS around with the objective that the back is standing up to you straight up. In any case, empty the two flexible pads on top.
Empty the power marker. Put the level wire on the slight space, push it left quick while pushing the shell right sagacious to the level wire at the same time. By and by oust the base part from the top bit of your Nintendo DS case, and put it in a safe spot. Direct your fixation toward the top bit of the case. Escape the point operator on the left side, roll the level wire and evacuate the ring on the contrary side. Next, look at the top screen. There are four screws concealed underneath pads on each corner around the top screen, empty both the covering and the screws. It is to some degree testing, so take as much time as is required. Exactly when you are set, push this top part with your thumbs on each side of the screen and your index fingers underneath, and slide it upwards. You should have the alternative to open the top shell. Roll the level wire and push right adroit to take it off completely.